Rheem GEN20B Manual do Operador Página 1

8OperationFigure 4: Main MenuTouch any button to activate the StatStation’s displayconsole when it is in Idle Mode Touch again to display theMain Men

92. Select Date & Time. Follow on-screen commandswithin Date Adjust to set the date and do the same inTime Adjust to set the time. Note that Navig

108. Enter the 9-digit Serial Number from the label on thetransmitter (see Controls and Features for location),following the instructions on the scree

11MaintenanceStatStation MaintenanceIf alkaline (2200mAH) batteries are used, display console willoperate for up to 40 hours, if the AC/DC Converter i

12TroubleshootingThe StatStation will report System Alerts for problems with your generator and standby system and the LED will flash red. Anaudible a

13System Alert Mode – Standby System FaultsSystem Alert Display Fault Cause Fault RemedySwitch G Coil Fail 1. Transfer switch generator coil failure.

14Illustrated Parts ListItem Part # Description1 197138GS ASSY, Transmitter2 202756GS ASSY, Display Console3 195728GS TRANSFORMER, Current4 201092GS A

15WarrantyBRIGGS & STRATTON POWER PRODUCTS GROUP, LLC ACCESSORY WARRANTY POLICYLIMITED WARRANTYBriggs & Stratton Power Products Group, LLC wil

Reserved

Thank you for your purchase of this Rheem/Ruud . This product is intended for use with Rheem and RuudHome Standby Generator sets ONLY. This is an opt

1FrançaisEspañolTable of ContentsImportant Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2Equipment Descriptio

2Important Safety InstructionsThis is the safety alert symbol. It is used to alertyou to potential personal injury hazards. Obey allsafety messages th

3INTRODUCTIONYour Rheem / Ruud StatStation is supplied with thiscombined “Installation and Operator’s Manual”. This is animportant document and shoul

4InstallationRead this Installation section carefully and becomefamiliar with Homeowner Responsibilities, InstallerResponsibilities, and the figures B

5Sensing Wire InterconnectionsAll wiring must be the proper size, properly supported andprotected by conduit, per code.Complete the following connecti

63. Using installer supplied 18AWG stranded wire, connecttransmitter’s 9th terminal from left on J4 to ‘R’ terminalon transfer switch control board (J

7A - Signal Strength — The number of bars to the right ofthe signal strength symbol indicate how strong thesignal is between display console and trans